SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White Multipurpose all in one elastic sealant and bonding adhesive Seals, Bonds and. 24 Jan SikaflexÆ FC. One part advanced polyurethane, elastomeric sealant/ adhesive. Description. Sikalex FC is a one-component, gun-grade. Specialist Construction Supplies for Repair, Maintenance, Building & Infrastructure. Sikaflex 11FC Data Sheet. Specification notes. Product: Sikaflex 11FC.
|Published (Last):||12 July 2006|
|PDF File Size:||11.42 Mb|
|ePub File Size:||6.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
All primers should be applied as thinly as possible. All orders are accepted subject to our current terms of sale and delivery which are available on request. Tensile Strength DIN 53 Users should always refer to the most recent issue of the Technical Data Sheet for the product concerned, copies of which will be supplied on request, or can be accessed on the internet under www.
Install the cartridge directly into a normal skeleton gun. Keep away from open flames and high heat. Masking tape should be applied where staining may occur.
Sika Primer 3 ml and 1 litre containers. Remove affected person to fresh air immediately and contact a physician. Exercise care, as with handling any chemical construction product.
SIKA Sikaflex 11FC All In One Adhesive Sealant Black Brown Grey White
Cut the plastic nozzle according to the desired bead width and then pierce the internal metal seal carefully to ensure that the passage of the sealant to the nozzle is not impeded. The Company reserves itself the right to change the formulation of Sika products if so required by new research and development. Flush immediately with water for 10 – 15 minutes and contact a physician.
In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, eikaflex from any other advice offered.
Priming is not usually necessary on new surfaces. Cured material can only be removed mechanically. Elongation at Break DIN 53 After the tc has been applied to the joint, it can be smoothed using a spatula lubricated with diluted washing-up liquid Install bond breaker cord in construction and expansion joints to prevent the sealant bonding to the base of the joint.
Remove contaminated clothing immediately. Ensure that skkaflex traces of release agents, curing compounds and silicone treatments are removed, or perform a site test to determine whether adequate adhesion can be obtained.
Porous surfaces and surfaces subjected to submersion after cure, should be primed with Sika Primer 3.
Initial Cure Tack Free. The proprietary rights of third parties must be observed. Refer to consumption chart on last page of this technical data sheet.
Safety goggles and chemical resistant gloves are recommended. Collect with suitable absorbent material. Light weight building components Sheet metal enclosures, sikkaflex roof flashings Silos and claddings Pipe entries, unions and sleeves Ventilation ducts Pointing of windows – fixing of window sills Kitchen installations Floor and construction joints.
Maximum joint width 30mm. Wash clothing before re-use. Dispose of in accordance with local regulations.
SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White
Ambient and surface temperatures must be between 50C to C during application. Wash hands immediately after use. When constructing a joint the following measurements have to be observed: Remove all loose material mechanically, with a wire brush, or by water or sand blasting as necessary. Contact Sika for further health and safety information. Concrete grey, brown, white and black.
Squeeze the trigger firmly to force the sealant through the nozzle. Protect from direct sunlight. Wash thoroughly with soap and water. All surfaces must be clean, sound, dry and properly cured.