Window Flashing ASTM E Presentation By: The Jacksonville Chapter, CSI. American Society for Testing and Materials (ASTM). ASTM E Standard Practice for Installation of Exterior Windows, Doors and Organization(s): American Society for Testing and Materials, ASTM. 26 Jul ASTM E Detailed information about window and door instal- lation is provided in the American Society for Testing and Materials (ASTM).
|Published (Last):||8 May 2016|
|PDF File Size:||18.7 Mb|
|ePub File Size:||5.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this practice. The installer should check with the manufacturer of factory-assembled units s2112 instructions for anchoring. Link to Active This link will always route to the current Active version of the standard.
Historical Version s – view previous versions of standard. Continuity with the Weather Barrier Systems. Installation Methods For Windows. Receive up to The photo below shows attaching the fin to the sheathing using nails screws are much preferred before the subsequent application of the self adhering flashing.
When using field-mulled units, follow manufacturer’s recommendations and make certain that they meet applicable codes. Related Issues and Procedures. The design of many windows took a turn in the last 30 plus years with the innovation of the finned window.
If you have a specific issue you would like me to touch on, please leave a comment below. Panning Systems and Subsills e2112 Weatherability.
Emergency Escape and Rescue Requirements. Furthermore, this practice does not purport to provide fail-safe installation methods, assurance or protection against installation deficiencies, or a standard by which architects can specify or ensure delivered performance.
The values shown in parentheses are for information only. It does not cover the fabrication or assembly of multiple units, whether such fabrication takes place in a factory or at the intended installation site.
This practice is not intended to limit or exclude other new procedures that may refine or further improve the effectiveness of fenestration installation. Work Item qstm – proposed revisions of this standard. Destructive Window Replacement Fin Type. Active view current version of standard. Now, I will review a newer technology that is becoming more and more innovative and popular-self adhering window flashing.
Water ingress into this area created havoc with the wall and window materials. In my last post, I reviewed the e2112 of water intrusion into building walls as related to window and building design changes that have occurred in the last twenty plus years.
ASTM E2112-07: Standard Practice for Installation of Exterior Windows, Doors and Skylights
Note 1—There are no ISO standards covering the primary subject matter of this practice. The perforated perimeter fin allowed the installer to screw or nail the window to the building sheathing helping to speed the installation. Where an asbestos hazard is known or suspected, refer to the ASTM Manual on Asbestos Controland to applicable state and federal regulations.
There are no ISO standards covering the primary subject matter of this practice. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
I have certainly not reviewed all of the related wall issues e. All self adhering flashing must be applied to a clean dry surface at an appropriate application temperature for maximum effectiveness.
ASTM E – 18 Standard Practice for Installation of Exterior Windows, Doors and Skylights
This practice is not intended to limit or exclude other new procedures that may refine or further improve the effectiveness of fenestration installation. Work Item s – proposed revisions of this standard. Description of Terms Specific to this Standard.
This practice does not cover the selection of appropriate fenestration products for a given application, nor the selection of other products or systems for use in the installation. Insulating or Filling the Rough Opening Gap. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this practice. Link to Active This link will always route to the e211 Active version of the standard.